Conductix-Wampfler Jay Electronique Jump, Installation And User Technical Manual

Page: 56 / 81

- 56 -
Jump - 332970E_A005
04/03/21
FR EN
4.2.5- Learning transmitter identity code
The repeater Jump can only operates with a single «Transmitter / Receiver»
pair. It is therefore necessary for the repeater to «learn» the transmitter
identity code.
The repeater Jump memory can only store one identity code.
For this procedure, the repeater must be configured with the same radio
channel as the transmitter.
The learning procedure is performed using the DIPswitch « configuration »
and cursor No. 4.
Learning procedure of the transmitter identity code :
1.
Turn off the repeater Jump .
2.
Place the cursor No. 4 on «ON» position.
3.
Turn the repeater Jump .
4.
The LEDs LD2 and LD3 flash continuously and synchronously. The
repeater is waiting for a radio message.
5.
Emit radio frames using the transmitter to be associated (send a «Start /
Horn» signal, or command).
6.
LD2 and LD3 LEDs flash alternately. The identity code is stored.
7.
Place the cursor No. 4 on «OFF» position.
A
B
LD1
LD5
CHARGE
ERROR
CONFIG
ERROR
CONFIGURATION
TENS UNITS
LD2
LD3
LD4
1 2 3 4 5 6 7 8
CONFIGURATION
Jump
(«Battery» version shown)
«ON» position = Learning the transmitter
identity code
«OFF» position
cursor No. 4
ON