Conductix-Wampfler Jay Electronique Jump, Installation And User Technical Manual

Page: 44 / 81

- 44 -
Jump - 332970E_A005
04/03/21
FR EN
1 - General safety rules
IMPORTANT :
When installing, be sure to take account of the 100ms processing delay which
you must add to the total passive stopping time of the system. See « Operating
principle » section.
Before use, you must configure the radio channel on which the repeater will
be operating. See « Configuration » section.

Service your equipment
and perform all the periodic checks as
may be required by the intensity with which your equipment is used.
If several « transmitter / repeater Jump / receiver » systems must be installed
in the same area, it is mandatory to configure them with different working
(receiving) frequency channels. See « Configuration » section.
It is essential to «learn» the identity code of the equipment with which the
repeater Jump will be used. See « Configuration » section.
Only use one repeater Jump within a «transmitter / receiver» pair, if the
transmission frequency is the same as the reception frequency.
except otherwise recommended. See « Operating principle » section.
This rule must be applied to keep the emergency stop function.
It is possible to use several repeaters Jump for a «transmitter / receiver» pair.
In this case, the reception frequency and the transmission frequency of the
repeater must be different. See «
Configuration
» section.
This rule must be applied to keep the emergency stop function.
!
!
!
!