CONDTROL Vector 100, User Manual

Page: 12 / 37

User manual
LASER DISTANCE METER
22
EN
23
User manual
LASER DISTANCE METER EN
Vector 100 CONDTROL Vector 100 CONDTROL
Memory
Short press Enter menu of functions.
Short press / Select function “Memory”
Short press
A number of the measurement/calculation result is
reflected in the symbol on the display.
Short press / Flip through saved measurement/calculation results.
Short press Exit the mode.
MESSAGE CODES
While operation, the following codes/symbols may appear on the display:
Message Cause Solution
ERR 1 Laser signal is too weak. Use a reflective plate.
ERR 2 Laser signal is too strong. Use a reflective plate.
ERR 3 Low battery. Charge the battery.
ERR 4 Failure of memory. Contact the service center.
ERR 5
Failure of calculation by
Pythagoras Theorem.
Repeat the measurement.
ERR 6
Measuring result exceeds
permissible measuring
range.
Please change to longer distance
product.
ERR 7 Failure of tilt sensor. Please contact service center.
Timer
Short press Enter menu of functions.
Short press / Select function “Timer”
Short press
Symbol will appear on display.
Default value is 5 seconds.
Short press / Set response time.
Short press
Start the timer.
As soon as response time runs out, measurement
will be taken.
Measurement result will appear in the main line.
Short press Exit the mode.
Bluetooth
Short press Enter menu of functions.
Short press / Select function “Bluetooth”
Short press
Switch on Bluetooth. Symbol turns blue.
Symbol appears on the display on the main
screen. Activate Bluetooth in the smartphone,
tablet PC or laptop. For further operation use
application Smart Measure CONDTROL.
Short press
Switch off Bluetooth. Symbol turns grey.
Symbol will disappear
from the display on the main screen.