Condec UPS3000, Installation, Operation & Maintenance Manual

Page: 11 / 94

Operation 7
UPS3110 Rack-mountable Series, See Figure 2-5 below, contains the following:
1. AC power cord, fuse holder and input receptacle (17).
2.
INPUT PRESSURE
port (16), 7/16-20, 37
o
-4 AN male fitting. Location of port for AC only units.
NOTE: The maximum input pressure, supplied by user, is noted below port.
3. The unit’s identification plate (15).
4.
VENT/VACUUM PORT
(19), 7/16-20, 37
o
-4 AN male fitting.
5. Optional if required items:
Connector J1 (14), 5 pin round MS style connector, for Serial or Analog Output communication board or
location of
Input Pressure
port for models with battery.
Connector J2 (18), 5 pin round connector, for the Freeze Mode Cable.
NOTE: For further information, see “Options, Replacement Kits” on page 54 .
Figure 2-5. UPS3110 Rack-mountable Pressure Calibrator Rear View
UPS3210 Rack-mountable Series, See Figure 2-6 on page 8, contains the following:
1. AC power cord, fuse holder and input receptacle (17).
2.
INPUT PRESSURE
port J3 (16), 7/16-20, 37
o
-4 AN male fitting.
NOTE: The maximum input pressure, supplied by user, is noted above port.
3. The unit’s identification plate (15).
4. Optional if required items:
Connector J1 (14), 5 pin round MS style connector, for Serial or Analog Output communication board.
Connector J2 (18), 5 pin round connector, for the Freeze Mode Cable.
Connector J4, located below identification plate, required for APC4000/APC4001 interface cable.
NOTE: For further information, see “Options, Replacement Kits” on page 54 .