Page
9
of
30
2.3 ACCESS
To access the PCB connections, programming panel and mounting holes (battery and fluid access
is covered in the relevant sections) remove the front cover by unscrewing the 2 set screws on
either side and unhooking it from the top of the case; refitting is the reverse process. Installation
cable entry is through the serrated grommet on the left back of the case.
2.4 MOUNTING
The Smoke Screen can be mounted on a ceiling or a wall using the simple standard bracket supplied
with the unit. This flush-fitting bracket maximizes security by concealing all the mounting fastenings
such that they can only be accessed, or the Smoke Screen dismounted, by dismantling the unit.
Moreover, the Smoke Screen has a tamper protection switch to provide an alert in the unlikely event that
it is disturbed. In all cases, the installer must attach the Smoke Screen to the building structure using
appropriate fasteners.
NB: When mounting the Smoke Screen ensure that the airflow through the vent holes in the rear
of the unit is not obstructed.
Wall and ceiling mounting
Ceiling or wall mounting is the same process except that rather than fixing the Smoke Screen
direct to a ceiling an intermediate unistrut section may be used or it can be suspended as
described in the next section. Attach the bracket to the wall or ceiling using appropriate fixings (1).
Carefully hook the slots on the back of the Smoke Screen onto the bracket (2) and slide along to
align the screw fixing holes. The unit will now hang on the bracket. Fit, and ensure tight, 4 x M6
set screws with washers in the holes in the back of the Smoke Screen alongside each mounting
slot (3) - access to the fixing holes is through the fluid and heater block compartments.
1
2
3
Summary of Contents for Titanium TI100
Page 2: ...Page 2 of 30 ...
Page 18: ...Page 18 of 30 ...
Page 19: ...Page 19 of 30 ...
