Concept2 MNV7760ds, Manual

Page: 142 / 154

142
EN
MNV7760ds
Connection to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the appliance.
We recommend using a separate outlet with a 10A circuit breaker.
• Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords. There is a risk of overheating.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
• Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is connected to
the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad
protective connection.
Connection of the water supply
• Before connecting the inlet hose to the water supply,
make sure that the water pressure is in the range of
0.04 to 1.00 MPa. When water pressure is higher, you
must install a pressure reducing valve.
• Connect the inlet hose to the tap with 3/4“ thread (Fig.
19). Make sure that the inlet hose is not bent, crushed
or entangled.
• When replacing the appliance always use a new inlet
hose !
• If the water pipes are new or they have not been used
for a longer period of time, run off a sufficient amount
of water before connecting the inlet hose to rinse the
pipes and wash away any impurities.
• If these safety instructions are not observed, it may
lead to blockage and damage to the appliance.
Obr. 14
Fig. 19
Safety
supply hose Common
supply hose