INSTALLATION AND OPERATING INSTRUCTIONS
DEFAULT SETTINGS
On delivery, the E+ will have the following defaults
Clock and Date:
pre-set.
Smoke Burst Time:
2 min of smoke production.
Auxiliary Timed Relay:
59 min from smoke on.
H/O Alarm:
enabled.
H/O Retrigger:
enabled.
UPS:
disabled.
UPS Alarm:
disabled.
Sound Repeat:
5 min.
Sound Silence:
2 hours.
Engineer Code:
1993.
ACTIVATION SIGNALS
The Smoke Screen E+ is designed to receive up to three activation signals:
‘
•
Set
’ input - normally closed (NC) relay opening when the Alarm Panel is ‘Set’.
‘
•
Trigger
’ input a NC relay opening when the Panel is in ‘Alarm’.
‘
•
Confirmation
’ input - a NC set of contacts opening on activation of a remote alarm ‘
Hold-off
’ (HO) such as a
PIR or a microswitch.
TRIGGERING SMOKE
The Smoke Screen E+ will produce smoke providing it is in a Ready state when the following conditions are met:
‘
•
Hold-off
’
attached
: Both ‘
Set
’ and ‘
Trigger
’ inputs are open and the ‘Hold-off’ is open providing confirmation.
No
•
‘
Hold-off
’
attached
: Both ‘
Set
’ and ‘
Trigger
’ inputs are open. If no Hold-off is attached the Level 2
parameter “HO Alarm” on/off should be changed to “Off”.
STOPPING SMOKE
Closing the ‘
Trigger
’ relay will
not
stop the production of smoke, which will continue for the preset time. Close the
‘
Set
’ relay to stop the smoke output instantly. Note that if the ‘
Set
’ and ‘
Trigger
’ inputs are connected together in
parallel and operated by one set of NC relay contacts opening the unit will stop producing smoke when the contact is
closed.
RE-TRIGGERING SMOKE
(Hold-off Attached). If, after it has made smoke for the preset time, the unit receives another HO alarm with an open
‘Set’ input it will ‘retrigger’ and make smoke again. To prevent this set the Level 2 parameter “HO Retrig“ to “Off”
and the Panel Alarm has to then re-arm before the system can produce Smoke. If required, there is a ‘Fleeting Input
Ignore’ function that can be set between 0 and 4.5 seconds in the Level 2 parameter ‘Alarm Ignore’ (the default
setting is 0.5 seconds).
