IP CAMERA QUICK START GUIDE
5. Troubleshooting
Common Issues Answered
Can’t find the camera IP address using MDLoad or other software:
• Make sure Ethernet and/or DC power cables are correctly connected to the camera.
• Make sure the PoE switch or DC power source meets the camera power requirements.
If using PoE, make sure the PoE switch is powered on.
• Make sure the PC is on the same network as the camera. Ping the camera’s IP address.
On your PC, go to Start>Programs>Accessories >Command Prompt. Type ping then the
camera’s local IP address and press Enter. If you get the message “Request timed out,”
PC and camera are not on the same network or camera is not connected. Camera is
connected if you receive replies.
• Camera set for static IP mode using an incorrect IP address. By default, the camera is set
for DHCP mode, which means it will automatically obtain an IP address from your router.
Reset the camera to factory default settings by removing the camera dome cover and
pressing the reset button for 5 seconds or more.
Can’t connect to the camera on a web browser using local IP address:
• See steps above.
• Verify the camera’s local IP address using one of the methods listed in
“Finding the Camera IP Address.”
Can’t connect to camera on a web browser using a DDNS address:
• Port forwarding not set up. Make sure the HTTP port (default: 80) is forwarded on your router
to the camera local IP address.
• Multiple cameras using same port number to connect. Configure each camera to use
different ports and port forward the new ports.
• DNS servers not set correctly in the camera network settings
• If DHCP is enabled on the camera and connected to an NVR, the NVR will configure the
default settings of the camera.
Can’t connect to camera video on a web browser:
• If using IE, make sure to install ActiveX plug-in or Adobe Flash Player.
• If using a browser other than IE. (e.g. Google Chrome, Apple Safari, Mozilla Firefox), make
sure the latest version of Adobe Flash Player is installed.
Video performs poorly on browser:
• Insufficient bandwidth available for high-quality stream1. Select stream 2 under Stream.
Stream 2 provides a lower resolution to conserve bandwidth and improve performance on
low-bandwidth connections.
• If using IE, click the message above the video area to use ActiveX plug-in instead of Flash
Player. ActiveX may provide smoother video performance.
Summary of Contents for CVP5325DNIR-IP2M/2.8
Page 12: ......
