Before Using Scale
1. Set switch on the base of scale to measure in kg (kilograms) or lb (pounds).
2. Set scale on floor. Surface must be level for accurate operation and safety.
Using the Weight Only Mode
• Instructions for customizing your Weight Watchers Body Fat Monitor and
Weight Tracker are below. However, the scale does not need to be programmed
to operate as a simple weigh scale.
• Tap the scale to turn it on. The display will light up.
• Wait until all digits light for 2 seconds, and “0.0” appears.
• Step on the scale and adjust your position according to the leveler
indicators on the display.
• The indicators show where you are off center. Dashes on the left show that too much
of your weight is on the left side of the scale, dashes on the right show that too much
of your weight is concentrated on the right side. Try to balance yourself in the center.
• Once you achieve the correct position, the center diamond will flash.
Off center position
Center position
• Weight reading appears and stays for 10 seconds.
• Display times out.
Customizing Your
Weight Watchers
®
Weight and Body Fat Monitor
This tracking scale can be customized for up to 4 users. While the customization
process is not difficult, it may be easiest to read all the instructions first to
familiarize yourself with them. Then keep the instruction manual handy as you
go through the process step by step. Should the scale time out during the setup
process (display goes dark), you can always start over.
Buttons: SET, up and down arrows, user buttons 1, 2, 3, and 4.
Setting Data for Body Fat/Hydration/BMI Measurement:
1. In power off mode, press the SET button.
2. All digits will be lit on LCD screen.
SETTING THE USER NUMBER
1. Press a user button (marked as 1, 2, 3, 4).
2. User number “P-1”, “P-2”, “P-3”, or “P-4” flashes on the LCD.
3. Press the SET button to confirm the user number. User number becomes stable.
WW71C_IB-6200A 3/21/07 7:49 AM Page 9
