![background image](http://html1.mh-extra.com/html/conair/cpg81c/cpg81c_instruction-and-styling-manual_2649599006.webp)
Never attempt to recharge primary batteries as this
may cause leakage, fire, or explosion.
Please be sure that the attachments are firmly in place
before turning the trimmer on.
BLADE REPLACEMENT
This trimmer comes with a detachable blade set,
which makes maintenance and replacement easy.
TO REMOVE THE BLADE SET:
t.BLF TVSF UIF USJNNFS JT JO UIF
“0-OFF” position.
t'BDJOH UIF GSPOU PG USJNNFS QSFTT
the blade on the teeth in the
direction away from you until they
pop out of the housing.
TO REPLACE THE BLADE SET:
t-PPLJOH BU UIF USJNNFS GSPN BCPWF ZPV XJMM TFF B
notch at the back of the trimmer.
t5IFSF JT B UBC PO UIF CMBEF TFU PO UIF CPUUPN
opposite the blades. Position that tab so that it fits
into the notch inside the trimmer head. Push the
blade set down onto the trimmer head until it snaps
into place.
Oiling blades:
For best results, put a drop of lubricating oil on the
blade approximately once a month. Motor bearings are
permanently lubricated – do not attempt to oil.
Notice – do not over oil:
This trimmer requires very little oiling. When it is
necessary to oil, turn trimmer on, hold the unit with
blades facing DOWN, and squeeze one drop of oil onto
blades. Wipe off excess with soft cloth.
Directions for use:
1.
Prior to turning trimmer on,
please be sure that battery has
been properly installed.
a) Slide battery compartment
cover to open.
b) Insert one AA alkaline battery into trimmer.
c) Replace battery cover.
2.
Turn trimmer on by pushing rocker switch on
bottom of unit forward to “I-ON” position. Please
be sure to turn trimmer off immediately after use
to preserve battery life.
3. There are two trimmer attachments for either a
medium or a long cut. Simply place one side of
attachment over the front of the blades and snap
the other side in place. To remove, pull tab away
from one side.
4.
Always purchase the correct size and grade of
battery most suitable for the intended use.
5. Replace all batteries of a set at the same time.
6. Clean the battery contacts and also those of the
device prior to battery installation.
7. Ensure the battery is installed correctly with regard
to polarity (+ and -).
8. Remove battery from equipment which is not to be
used for an extended period of time.
9. Remove used batteries promptly.
10. Store unused batteries in their original packaging,
away from metal objects that could short-circuit
them. Never short-circuit batteries.
11. Never dispose of batteries in fire, except under
conditions of controlled incineration. (Failure to
observe this precaution may result in an explosion).
PALM-PRO MICRO
PET TRIMMER