DeviceMaster Installation and Configuration Guide
: 2000594 Rev. F
RedBoot Procedures - 137
RedBoot Procedures
RedBoot Command Overview
The following table is an overview of RedBoot commands available. After accessing RedBoot, you can review
the list of commands online by entering
help
and pressing the
Enter
key.
For more detailed information, see the
eCos Reference Manual
downloads.comtrol.com/dev_mstr/rts/software/redboot/user_guide
.
RedBoot Commands
auth
{noaccess, none, basic, md5, invalid}
Sets or displays web authentication. The default is set to
none
, which
means that there is no authentication required to access the web server.
To deny access to the web server, click
noaccess
or
invalid
. If access is
attempted, a message appears to notify the user that access is denied.
To configure the web server to request an un-encrypted password, click
basic
. To configure the web server to request an encrypted password, click
md5
. (Some browsers do not support the
md5
command.)
boardrev†
Displays the board revision.
cache [ON | OFF]
Manages machine caches.
channel [-1|<channel number>]
Displays or switches the console channel.
chassis
Displays chassis information.
cksum -b <location> -l <length>
Computes a 32-bit checksum [POSIX algorithm] for a range of memory.
clearconfig
Clears the application configuration.
disable
Disables automatic load of the default application.
fis {cmds}
Manages flash images. See Chapter 2 of the
{cmds}
information.
flash
Shows flash information.
go [-w <timeout>] [-c] [-n] [entry]
Executes code at a location.
help <topic>
Displays available RedBoot commands.
history
Displays command history.
ip [addr mask gateway]
Displays or sets the IP address configuration.
load [-r] [-v] [-h <host>]
[-p <TCP port>]
[-m <varies>]
[-c <channel_number>]
[-b <base_address>]
<file_name>
Loads a file from TFTP server or XModem.
loop 232|422|int port-number
Runs loopback test on port. The DeviceMaster Serial Hub does not
support this command.
mac†
Displays Ethernet MAC address.
model†
Shows model number.
password {password}
Sets or deletes the password.
ping [-v] [-n <count>]
[-l <length>] [-t <timeout>]
[-r <rate>]
[-i <IP_addr>] -h <IP_addr>
Network connectivity test.
reset
Resets the DeviceMaster.
secureconf [disable|enable]
Sets or displays secure config enable.
securedata [disable|enable]
Sets or displays secure data enable.
