3.
Designate one AP as the AP Controller which will manage all other
connected APs (up to 5).
4.
Connect a computer to the AP Controller using an Ethernet cable.
Connect the AP Controller to power and power on the unit.
5.
Open a web browser and enter the AP Controller’s IP address in the
address field. The default IP address is
192.168.2.2.
DHCP is enabled on the access point by default. If no DHCP
Service is found, the access point will default to IP address
192.168.2.2.
Your computer’s IP address must be in the same subnet as the AP
Controller. 192.168.2.10 is being used in this example.
6.
Enter the username & password to login. The default username &
password are
admin
&
1234
respectively.
7.
You will arrive at the Access Point Information screen. Go to
à
“Operation
Mode”
and select
“AP Controller Mode”
from the drop down menu.
Summary of Contents for WAP-EN300C
Page 1: ...WAP EN300C NMS User Manual Version 1 0 June 2016 ...
Page 12: ...Toolbox The Toolbox panel provides a network diagnostic tools ping and trace route ...
Page 55: ...IV 5 6 Advanced IV 5 6 1 System Security Configure the NMS system login name and password ...
Page 72: ...frames for wireless clients ...