Comtrend Corporation L9VVR3060U, User Manual

Page: 12 / 121

11
2.2 LED Indicators
The front panel LED indicators are shown below and explained in the following table.
This information can be used to check the status of the device and its connections.
LED Color Mode Function
POWER
GREEN
On The device is powered up.
Off The device is powered down.
RED On
POST (Power On Self Test) failure or other
malfunction. A malfunction is any error of internal
sequence or state that will prevent the device from
connecting to the DSLAM or passing customer data.
ETH WAN
GREEN
On WAN is connected in 1000 Mbps.
Off Ethernet WAN is not connected.
Blink In TX/RX over 1000 Mbps
ORANGE
On Ethernet is connected in 10/100 Mbps.
Off Ethernet WAN is not connected.
Blink In TX/RX over 10/100 Mbps.
ETH 4 to 1
GREEN
On Ethernet is connected at 1000 Mbps.
Off Ethernet is not connected.
Blink In TX/RX over 1000 Mbps.
ORANGE
On Ethernet is connected at 10/100 Mbps.
Off Ethernet is not connected.
Blink In TX/RX over 10/100 Mbps.
WPS
GREEN
On WPS(2.4G) WPS enabled and client connected to
WLAN.
Off WPS(2.4G) WPS disabled.
Blink WPS(2.4G) WPS connection in progress, 120
seconds or until client connected.
ORANGE
On WPS(5G WPS enabled and client connected to
WLAN.
Off WPS(5G) WPS disabled.
Blink WPS(5G) WPS connection in progress, 120 seconds
or until client connected.
WiFi
2.4G
GREEN
On The wireless module is ready.
(i.e. installed and enabled).
Off
The wireless module is not ready.
(i.e. either not installed or disabled).
Blink Data transmitting or receiving over WLAN.