Comtrend Corporation AR-5310u, User Manual

Page: 10 / 75

9
Chapter 2 Installation
2.1 Hardware Setup
Non-stackable
This device is not stackable – do not place units on top of each other, otherwise damage could
occur.
Follow the instructions below to complete the hardware setup.
BACK PANEL
The figure below shows the back panel of the device.
DSL
Connect to the DSL port with the DSL RJ11 cable.
LAN (Ethernet) Ports
You can connect the router to up to four LAN devices using RJ45 cables. The ports are
auto-sensing MDI/X and either straight-through or crossover cable can be used.
USB HOST PORT
A USB 2.0 host port supports compatible printers. See Appendix F for setup instructions. Support
for other devices may be added in future firmware upgrades.
Reset Button
Restore the default parameters of the device by pressing the Reset button for 10 seconds. After
the device has rebooted successfully, the front panel should display as expected (see section
2.2
Front Panel for details).
NOTE: If pressed down for more than 60 seconds, the AR-5313u will go into a firmware update
state (CFE boot mode). The firmware can then be updated using an Internet browser
pointed to the default IP address.