Firmware Update Procedure, HPA
MNC-0500-014
3 of 6
Revision B
Firmware Update Procedure, HPA
Note
This document applies to HPAs with Rabbit Based
Microprocessors.
Overview
This chapter provides the service technician with information
and a procedure that will allow the equipment firmware to be
updated. Contact Customer Service for assistance. Contact
information is located in the chapter titled
Overview
.
The following files, listed by part description, are required to
operate your equipment. The specific part numbers, 800-XXXX-
XXX, 803-XXXX-XXX, 807-XXXX-XXX, and 808-XXXX-XXX are
listed in the appendix titled
Firmware
.
The middle four digits (XXXX) of the 803 correspond to the
middle four digits (XXXX) of the 808 part number.
•
800-XXXX-XXX
Bill of material for the files required to operate your equipment.
The last three digits (XXX) match the last three digits (XXX) of the 807-XXXX-
XXX
•
Part Number 803-XXXX-XXX consists of the set of support files
listed below:
coldload.bin
pilot.bin
flash.ini
Rfu.exe
•
Part Number 807-XXXX-XXX is the model configuration file. This is
a text file that is loaded at the factory to configure the HPA to a
predefined option.
•
Part Number 808-XXXX-XXX is the firmware executable for your
equipment.
Required Items
The following equipment is required to perform this procedure:
•
PC (Personal Computer) — laptop or desktop with a serial port.
•
A NULL modem cable.
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
