CDM-600L Satellite Modem
Revision 0
Remote Control
MN/CDM600L.IOM
15–4
15.5.3 Instruction
Code
This is a three-character alphabetic sequence which identifies the subject of the message.
Wherever possible, the instruction codes have been chosen to have some significance.
For example TFQ for transmit frequency, RMD for receive modulation type, etc. This
aids in the readability of the message, should it be displayed in its raw ASCII form. Only
upper case alphabetic characters may be used (A-Z, ASCII codes 65 - 90).
15.5.4
Instruction Code Qualifier
This is a single character which further qualifies the preceding instruction code.
Code Qualifiers obey the following rules:
1)
From Controller to Target, the only permitted values are:
= (ASCII code 61)
? (ASCII code 63)
They have these meanings:
The ‘=’ code (controller to target) is used as the assignment operator, and is used to
indicate that the parameter defined by the preceding byte should be set to the value of the
argument(s) which follow it.
For example, in a message from controller to target, TFQ=0950.0000 would mean ‘set
the transmit frequency to 70 MHz’
The ‘?’ code (controller to target) is used as the query operator, and is used to indicate
that the target should return the current value of the parameter defined by the preceding
byte.
For example, in a message from controller to target, TFQ? would mean ‘return the
current value of the transmit frequency’
2)
From Target to Controller, the only permitted values are:
= (ASCII code 61)
? (ASCII code 63)
! (ASCII code 33)
* (ASCII code 42)
# (ASCII code 35)
~
(ASCII Code 126)
They have these meanings:
The ‘=’ code (target to controller) is used in two ways:
Summary of Contents for CDM-600L
Page 2: ......
Page 4: ......
Page 206: ...2114 WEST 7TH STREET TEMPE ARIZONA 85281 USA 480 333 2200 PHONE 480 333 2161 FAX ...