CDM-600L Satellite Modem
Revision 0
Front Panel Operation
MN/CDM600L.IOM
6–21
6.3.1.8 CONFIG:
EDMAC
Select either IDLE, MASTER, or SLAVE, using the [
↑
] [
↓
] arrow keys, then press
ENTER.
An EDMAC MASTER is a unit which is local to the M&C computer, and which
passes messages, via the overhead, to a distant-end modem. The MASTER
address will always end in 0.
An EDMAC SLAVE is a unit which is not local to the M&C computer, which is
at the distant-end of a satellite link. The SLAVE EDMAC address will always
end in 1.
See the Chapter 11 EDMAC operation specified in this manual.
6.3.1.9 CONFIG:
MISC
Select the parameter to edit using the [
←
] [
→
] arrow keys, then press ENTER.
CONFIG:
MISC:
G.703
CODE
Parameters may only be edited if the Interface Type is G.703.
Use the [
←
] [
→
] arrow keys to select the parameter to edit. Select either appropriate
G.703 code using the [
↑
] [
↓
] arrow keys, then press ENTER.
Note that the choices displayed here will depend on the G.703 interface type which has
been selected. The choices are:
•
HDB3 (for E1 and E2 operation)
•
B8ZS ( for T1 and unbalanced T2 operation)
•
B6ZS (for balanced T2 operation)
EDMAC MODE = MASTER (IDLE/MASTER/SLAVE)
EDMAC ADDRESS = XXXX
MISC: G.703-LINE-CODE IDR-ESC-TYPE
ADPCM-AUDIO-VOLUME HIGH-RATE-IBS-ESC
TX G703 CODE = AMI (AMI,B8ZS)
RX G703 CODE = AMI (AMI,B8ZS)
Summary of Contents for CDM-600L
Page 2: ......
Page 4: ......
Page 206: ...2114 WEST 7TH STREET TEMPE ARIZONA 85281 USA 480 333 2200 PHONE 480 333 2161 FAX ...
