C
OMREX
C
ORPORATION
12
STAC Product Manual
13
See the
A
UTOMATIC
M
IX
-M
INUS
section on page 37 for a description of this
function. Most applications should leave this switch set
OFF
.
ON
=
VIP/Hotline Mode
enabled. In this mode, the system’s last two phone
lines (lines 5-6 on STAC6 or lines 11-12 on STAC12) are treated separately
for talk show guests or studio hotline functions. These lines are removed
from the
Priority Queue,
and
Auto Attendant
will not answer these lines.
OFF
= All lines will participate in the
Priority Queue
and
Auto Attendant
functions (if enabled).
ON
=
Auto Attendant
will answer incoming calls on the sixth ring.
OFF
=
Auto Attendant
will answer incoming calls on the second ring.
ON
=
Loop-Thru
sensing is ignored.
OFF
=
Loop-Thru
sensing is enabled. When enabled, this function disables
access to phone lines that have been picked up downstream of STAC.
“Downstream” devices are those connected via the telephone line
Loop-
Thru
ports on STAC. When this function is enabled, a downstream device
going off-hook will be indicated by a special light sequence on the control
surfaces, and those lines will be disabled on STAC until the downstream
device goes on-hook.
Note: When the STAC has taken a line “off hook”, it is always disabled at
the
Loop-Thru
jack.
ON
= Lines must be dropped manually by control surfaces or STAC IP.
OFF
= Lines will drop on sensing of momentary break in battery voltage
(calling party disconnect signal).
ON
= Disable
Auto Attendant
regardless of control surface settings.
OFF
= Control surfaces determine
Auto Attendant
function.
For future use.
8) A
UTO
M
IX
-M
INUS
9) VIP/H
OTLINE
M
ODE
10) A
UTO
A
TTENDANT
2/6
R
INGS
11) L
OOP
T
HRU
S
ENSE
D
ISABLE
12) A
UTO
D
ISCONNECT
D
ISABLE
13) A
UTO
A
TTENDANT
G
LOBAL
D
ISABLE
14, 15 & 16) F
UTURE