1. LOCATION OF THE DEVICE
The thermostat of the
COMPUTHERM
Q3 RF
type device can
be freely moved in your residence. It is reasonable to locate it in
a room used regularly or for many hours per day so that it is in
the direction of natural ventilation in the room but protected from
drought or extreme heat (e.g. direct sunlight, refrigerator, chimney,
etc). Its optimal location is 1.5 m above floor level. It can be placed
on its own stand or can be mounted on a wall.
IMPORTANT WARNING!
If the radiator valves in your flat
are equipped with a thermostatic head, replace the thermostatic
head of the radiator valve with manual control knob or adjust it
to maximum temperature in the room where the room thermostat
is to be located, otherwise the thermostatic head may disturb the
temperature control of the flat.
2. PUTTING THE THERMOSTAT INTO OPERATION,
BASIC SETTINGS
To put the thermostat into operation,
detach the rear panel of the thermostat from
the front panel by loosening the screws at the
bottom of the cover as shown in the figure.
The battery compartment is in the inner side of the front
panel of the housing. Insert 2 AA alkaline batteries (LR6 type) in
accordance with the diagram in the battery compartment. After the
batteries have been inserted, the display flashes the measured
room temperature. (If this information fails to appear on the display,
press the „
RESET
” button with a wooden or plastic stick. To press
the button, do not use any electrically conductive materials or
graphite pencil).
- 4 -
