CSW-HD440NEXT Page 19 of 19
or HD projector that use HDMI inputs. Note that high-speed HDMI cables are
recommended for the distances that are required for each connection.
4. Plug in IR transmitters to the back of the Matrix Selector Switcher unit (IR
TX), the transmitters are labeled IR TX, place in front of the IR receiver of the
source, ensure that each emitter is placed in front of the IR receiver eye.
Double-sided adhesive tape provided.
5. Plug in IR receivers to the port of the E50IR Receiver display receivers (sold
separately) ,the receivers are labeled IR RX, use provided double-sided
adhesive tape to stick emitters at each display at a desired place that will
receive a remote signal.
6. For power, plug in the source first, followed by the Matrix Selector Switcher
(power supply included), followed by the display receivers, followed by each
output connected.
7. Power on each device in the same sequence.
At this point each display connected should display the assigned source (input 1
at default when powered on initially), scroll through each of the sources on
each display to ensure everything is in working order. Use included IR remote
at each display receiver to test switching function between sources and IR
function itself. If a display is having difficulty receiving a signal, access the
display’s menu and adjust the resolution (lowest to highest until signal is
displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher.
If the IR remote function is not responding, check the emitters to ensure they
are placed correctly and are plugged into the correct IR jacks on the Matrix
Selector Switcher unit.
1-800-526-0242
Mailing Address:
80 Little Falls Road
Fairfield, NJ 07004
