26 |
P a g e
Edge 540/2.6m
Place some masking tape on the fuselage roughly where your
mark will be. With the straightedge on the canopy seat mark a line
using the measurement you just established. Now that you have
the servo arm position marked on the outside of the fuselage, you
can use a string line to mark the horizontal cable line.
You will need a couple of meters of string with a loop at one end.
Attach the loop to the rudder horn using the 3mm bolts provided.
Centre the string loop between the control horns, then position
the other end of the string over the servo mark. Tension the
string so there is no sag, then hold in place with some masking
tape. You have just established your horizontal cable line. Place
some masking tape on the fuselage about 300mm from the
rudder control horn. Using the string line as a reference, use a
rule to mark a horizontal line. You need to cut a slot about 30mm
long. Make 2 marks on your horizontal line 320mm and 350mm
from the rear edge of the fuselage.
You can double check the exit measurement by running the
string along the bottom of the fuselage. Flip the model upside
down, and directly underneath the servo draw the servo arm
measurements onto so masking tape. Remember this
measurement is dependent on which servo arms you use.