6
Section 4
Operation
This section describes how to set up and make measurements with the HT-20KVPac unit.
We recommend that you read the entire section carefully so that you can use all of its features.
Setting up the HT-20KVPac
The HT-20KVPac is shipped in a special protective container that should prevent damage
during shipping. The container will include the following:
The HT-20KVPac Dielectric Withstand Tester
A black 18 AWG Test Return Lead (Alligator Clip/Banana Plug ends)
A red 18 AWG High Voltage Test Lead (Alligator Clip/High Voltage Plug ends)
A Power Cord.
This Instruction Manual
18 AWG Line Power
Cord
GL Return Test Lead
Red 18 AWG High
Voltage Test Lead
Table 4-1. Shipment Cables & Connectors
Use the original shipping container for subsequent shipping. If the original shipping
container is not available, be sure that adequate protection is provided to prevent damage during
shipment.
AC Line Voltage Requirements and Fuse Replacement
Connect the HT-20KVPac only to the voltage source indicated on the rear panel.
There is a user-replaceable fuse located on the front panel. The fuse rating is printed on
the front panel. For continued protection against risk of fire, replace only with same type and
rating of fuse. The AC Power switch should be turned off while the fuse is being replaced.
Front and Rear Panel Features
Before using the HT-20KVPac tester, take a few minutes to become familiar with the use
of its controls, indicators, and connectors. The front panel features of the HT-20KVPac are
shown in Figure 4-1 and described in Table 4-2.
