![Compaq Prolinea 4100 Maintenance & Serice Manual Download Page 102](http://html1.mh-extra.com/html/compaq/prolinea-4100/prolinea-4100_maintenance-and-serice-manual_2645348102.webp)
Reverse the above procedure to install the mounting bracket and the hard
drive. Be sure that the offset flanges on the bracket engage the cutout in
the side of the drive cage.
Chapter 5.8 Accessible Drives
The following procedures assume the following accessible drive
configurations.
o DT3 has a 3.5-inch diskette drive in the upper drive bay and optional
diskette drive, tape drive, or CD-ROM drive in the lower drive bay.
o DT4 has an optional CD-ROM drive or tape drive in the upper drive bay, a
3.5-inch diskette drive in the middle drive bay, and an optional
diskette drive, tape drive, or CD-ROM drive in the lower drive bay.
Other drive configurations can be removed and replaced with these same
procedures.
IMPORTANT: Pay particular attention to the routing and folding of the
power and signal cables for the accessible drives. If it
becomes necessary to replace one of these cables, it is
essential that the cable is folded and routed in a similar
Summary of Contents for Prolinea 4100
