3-5
Compaq Professional Workstation AP200 Maintenance and Service Guide
Front Bezel
To remove the front bezel:
CAUTION: Before removing the access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the
power cord is disconnected from the grounded AC outlet.
1.
Perform the service preparations shown on page 3-2.
2.
Remove the access panel.
3.
Press in on the two release tabs
1, then rotate the front bezel away from the chassis to
remove it from the workstation
2.
1
2
2
Figure 3-5. Removing the front bezel
To replace the front bezel, reverse the above procedure.
NOTE: When replacing the front bezel, be sure the bottom hinge points are properly placed in
the chassis before rotating the front bezel back into its original position.
