Installing and Removing Components
5-12 AlphaServer 1000A Rackmount Owner’s Guide
Removing an Option Card
To remove an EISA, ISA, or PCI option card from the system unit, refer to Figure 5-7 and
perform these steps:
_________________________Caution____________________________
Static electricity can damage electronic components. Use an antistatic wriststrap
when you handle these components. See the section "Antistatic Precautions."
____________________________________________________________
1.
Disconnect any cables connected to the external or internal ports on the option card
you want to remove.
2.
Remove the slot cover screws (2) securing the option card to the chassis.
3.
Carefully disconnect the option card (1) from the slot connectors on the system board
and remove it from the system.
4.
If you intend to leave the option slot vacant, install a slot cover and secure it to the
chassis using the screw you removed.
5.
When you finish removing or installing internal options, reassemble the system
following the procedure described in "Replacing the Top Panel," earlier in this
chapter.
Testing an Option Card Installation
To test an option card installation, perform the steps in Table 5–1 and refer to
Example 5–1.
_________________________Caution____________________________
Reassemble the system following the procedures listed in "Replacing the Top
Panel."
____________________________________________________________
