2-20
Compaq Utilities
FailSafe Boot Block ROM
The FailSafe Boot Block ROM allows for system recovery in the unlikely event of a ROM flash
failure, for example, if a power failure occurs during a ROM upgrade. The Boot Block is a flash-
protected section of the ROM that checks to validate the system ROM each time power to the system
is turned on.
■
If the system ROM is valid, the system starts normally.
■
If the system ROM fails the validation check, the FailSafe Boot Block ROM provides enough
support to start the system from a ROMPaq diskette, which will program the system ROM with a
valid image.
Because there is no video or hard drive support from the Boot Block ROM, the keyboard lights
communicate information. When the Boot Block detects an invalid system ROM, the system sounds
a series of beeps (one long and three short) and flashes the three keyboard lights.
To recover the system after hearing the FailSafe Boot Block beeps, complete the following steps:
1. Remove any diskettes from the diskette drive and turn off the power.
2. Insert a ROMPaq diskette into the diskette drive.
3. Turn on power to the system
If a Setup Password has been established, the Caps Lock light will turn on.
4. Enter the Setup Password.
When the system successfully starts from the diskette and reprograms the ROM, the three
keyboard lights will turn on.
Summary of Contents for 244100-005 - Deskpro 2000 - 16 MB RAM
