17
4.3.4 In case of strength member termination on the shelf (use
FIST-GSS2-CT-BS-2): mount the cable plate, the strength member
connectors, the black stand-off and the tie-wraps as shown in 4.3.6.
Use the plastic spacers between plate and shelf. The distance between
the plate and the right side of the shelf X is 8 cm for a 19” shelf and
10,5 cm for an ETSI shelf and 2 cm for 15” shelf.
4.3.5 Remove 3.5 m cable jacket. Leave 55 mm of the strength
member.
X
4.3.6 Mount the transportation tubes as shown. Protect the tubes with
a 200 mm spiral tubing and make sure the bend is smooth.
4.3.7 Install the cables. Strip the loose tube at 50 mm from the cable
jacket end. Cut the transportation tube at 60 mm from the cable jacket
end. Slide a 75 mm long FOPT-CT over the transition. If the loose tube
diameter < 2,3 mm the use of the FOPT-CT is not needed. (In this case
don’t cut the transportation tubes too short).
5 Termination of the pigtail
5.1
Route the pigtails without leaving any slack through the trumpet,
through the KTU bracket to the correct tray. Mark in the middle or at the
end of the tray to have some slack for sliding the tray.
5.3
Mount the 2 pieces of the KTU as shown.
5.2
Remove the jacket beyond the marking point. Cut away the
Kevlar leaving 50-100 mm from the edge of the jacket. Cut the pigtails
leaving ± 1.7 m length after the marking point.
