2
Table of Contents......................... 2
Safety Information....................... 2
Pre-Installation............................. 4
Planning Installation.................... 4
Specifications................................. 4
Tools Required............................... 4
Package Contents........................ 5
Hardware Included
............................ 5
Installation...................................... 7
Mounting Methods........................ 6
Operation ...................................... 31
Care and Cleaning........................ 32
Troubleshooting............................ 32
Warranty.......................................... 3
Table of Contents
Safety Information
IMPORTANT
This product must be installed in accordance with the applicable National Electrical Code and
local building codes by a person familiar with the construction and operation of the product and
the hazards involved.
PRECAUTIONS
☐
Please read and understand this entire
manual before attempting to assemble,
install, or operate this light fixture.
☐
This light fixture requires a 120-277 volt
AC power source.
☐
Some codes require installation by a
qualified electrician.
☐
This light fixture must be properly
grounded.
☐
Make sure connections are secure
using wire nuts, crimp-on lugs or other
approved connecting devices.
☐
This light fixture should be installed
outdoors on a wall or a pole.
WARNING:
breaker or fuse. Place tape over the circuit
light fixture.
CAUTION:
Burn hazard. Allow the light fixture
to cool before touching.
NOTE:
For dimming, use a 0-10 volt dimming
switch.
NOTE:
FCC Regulations state that any
unauthorized changes or modifications to
this equipment not expressly approved by the
manufacturer could void the user’s authorization
to operate this equipment.
IMPORTANT:
The device is tested and found to comply with Part 15 of the FCC Rules. Operation is subject
to two conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including any interference that may cause undesired operation.
These limits are designed to provide reasonable protections against harmful interference when the
equipment is operated in a commercial environment.
