6
Installation (continued)
NOTE:
The mounting base screws (C) come pre-installed
2
Removing the mounting base
□
Loosen the two mounting base screws (C) using a Phillips
□
and stays connected on the hinge. (Fig. 2)
CAUTION:
DO NOT touch the LED and photocell lens (E)
Fig. 1
C
D
3
Removing the knock outs on the
mounting base
□
For junction box mount: Measure the size of your junction
to knock out.
□
For 3-1/4 in. junction box: Knock out two holes in the inner
ring.
□
For 4 in. junction box: Knock out two holes on the outer
ring.
□
For surface mount: Measure the distance between two
holes, pre-drill holes into the mounting surface, and drill
holes on the desired ring accordingly.
□
Use a power drill to drill out the two holes.
NOTE:
If necessary, you may drill out mounting holes
through the back plate housing to correspond with the
junction box or wall surface for level mounting.
Fig. 2
