Step 19
: Secure the remaining 2 8x12/ 20mm bolts and 8mm washers into the
touchscreen’s lower VESA mounting holes through the lower part 000.
Step 20
: Tighten the 4 8x20mm CHB’s on the lower part 000
Step 21
: The actuators need to be initialized to function correctly.
Using the buttons shown above lower the touchscreen until it hits its lowest vertical
limit (indicated by a 1 on the LED screen on the control panel). Continue to hold the
button down until the actuators move up slightly.
Press the rotating arrow button and lower the touchscreen to the horizontal
position (indicated by a 2 on the LED control panel). Continue to hold the button
down until the actuators move up slightly.
Once both steps are completed the trolley is ready to go.
Additional Notes
Transportation: When moving your tilt trolley around your campus, place the
touchscreen in the vertical position and lower the touchscreen to within 10-
20mm of the castor legs (parts 001). Ensure all leads are stowed safely and
out of the way of moving parts.
Safe Operation of the trolley: The Lift actuators have a built in safety feature
(Pizo) where any change in pressure between sides will automatically stop
and reverse the movement of the unit. This will also happen if the panel is
lowered onto the castor legs.
Error E01: The E01 error will appear if the actuators get themselves out of
sync. If you get the E01 error follow the initialising procredure in step 20.
For any other errors please contact CommBox support on 02 9975 6001, or
alternatively you can log it through the website
here
.
Summary of Contents for Tilt Trolley
Page 1: ......
