INST
ALLA
TION
POWER UP
SETUP
USAGE GUIDE
ADV
ANCED MENUS
INST
ALLA
TION
POWER UP
SETUP
USAGE GUIDE
ADV
ANCED MENUS
The Advanced Installer Configuration Menu provides access to system configuration
options, diagnostics, and identification information.
e
ntering
anD
n
aVigating
the
a
DVanCeD
i
nStaller
C
onfiguration
m
enu
/S
erViCe
i
nformation
On the Home Screen Display, touch the
Menu
key to display additional key choices.
20
17
a
dvanced
I
nstaller
c
onfIguratIon
M
enu
u
sIng
the
t
herMostat
C
hooSe
the
S
yStem
S
etting
Touch the SYSTEM key to select:
Heat:
Thermostat controls only the heating
system.
Off:
Heating and Cooling systems are off.
Cool:
Thermostat controls only the cooling
system.
Em:
Setting is available only when the
system is a heat pump. This setting controls
the auxiliary heat source in a heat pump
system. The auxiliary heat source may be
electric strip heaters or a gas furnace (dual
fuel system).
Auto:
Auto Changeover is used in areas
where both heating and cooling may be
required on the same day. Auto allows
the thermostat to automatically switch
between heating and cooling operation.
a
uxiliary
h
eating
When the thermostat is configured for Heat Pump mode and an outside remote sensor
is installed, the thermostat can monitor the outside temperature. When the outside
temperature falls below a user selectable temperature, the thermostat will energize the
auxiliary heat source. Depending on the type of auxiliary heat source, the thermostat
may shut down the compressor.
P
rogrammaBle
m
oDe
If Program days per week is set for 7 (7 days) in the Thermostat Options Configuration
Menu the thermostat can follow the program entered. Press the
Run Schedule
key. The
thermostat will follow the program that you entered or the factory program.
Touch and hold the
Installer Config
key
for approximately 3 seconds to enter the
Thermostat Options Configuration.
Touch and hold the Installer Config key
again for approximately 3 seconds to
enter the Advanced Installer Configuration
menu.
1
2
f
ault
S
tatuS
The display will change to the Fault Screen
indicating any faults that may be present
in the indoor or outdoor equipment.
Advanced
will appear on the right of the
display to indicate the Advanced Installer
Configuration Menu.
If a fault is present, the Fault Screen will
show the equipment and an error code
with a description of the fault. Touch
or keys to view the fault status of any
remaining equipment found.
If no errors are present, the scroll area will
indicate
NO FAULTS
. Touch or keys
to view the fault status of any remaining
equipment found. Touch
or
to
change the display to the Equipment User
Menu.
