COMFORT-AIRE RADS Series, Owner'S Manual

Page: 17 / 32

 Page 17 
Installation Instructions
1 2 Long Screws
And Locknuts
Left
Right
Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Locknut
Mark
1 2 Long Screws
and Locknuts
L ocking S cre
w
7/16"Locking Screw
and Washer
1 /
4
5 /
8
5
Side Louvers
Window Sash
Window Sill
Sill Angle Bracket
1 5
About1 / to1 /
4 8
Measure from
the cabinet edge.
3 4 (or1 )Long
Hex-head Screw
/2
1. Hold each support bracket flush against outside
of sill, and tight to bottom of cabinet as shown in
Fig.15A. Mark brackets at top level of sill and remove.
2. Assemble sill angle bracket to support brackets
at the marked position(Fig.15B).
Hand tighten, but allow for any changes later.
3. Install support brackets(with sill angle brackets
attached) to correct hole in bottom of cabinet as
shown in Fig.16.
4. Tighten all 6 bolts securely.
1. Carefully raise window to expose filler panel
locking screws. Loosen screws so filler panels
slide easily.
2. Extend panels to fill window opening
completely. Tighten locking screws on top
(Fig.17).
3. Close window behind top angle.
Fig.13 Fig.13B
Fig.15B
Fig.16
Fig.17
Fig.14
Fig.15A
5
Install Support Bracket
6
Extend Window Filler Panels
NOTE: Check that air conditioner is tilted back about
1 "to 1 " (tilted about 3
°
to 4
°
downward to the
outside). After proper installation, condensate should
not drain from the overflow drain hole during
normal use,correct the slope otherwise (Fig .14).