IE-SNC-Tx6xx-07
8
•
check if there is no IP address conflict when you connect the device into
network for the first time. The device has from factory set the IP address to
192.168.1.213
. This address must be changed according to information from the
previous step. When you installing several new devices, connect them to the
network one after another.
•
connect probe Pt1000 to Web Sensor T4611
•
connect the Ethernet connector
•
if the power over Ethernet (PoE) is not used, connect the power adapter
5V/250mA
•
LEDs on LAN connector should blink after connecting the power and LCD
start showing measured values.
Device settings
•
run configuration software TSensor on your PC
•
switch to an
Ethernet
communication interface
•
press button
Find device...
•
the window shows all available devices on your network
