8
Fitting the housing and anti-tear tamper
It is now possible to
fi
t the housing to the wall:
1. Identify the position in which the switchboard is to be
fi
tted and make sure that no cable or service ducts (pipes, drain pipes etc.) run through or
close to the
fi
xing holes. Then, with the help of a pencil or marker pen, carefully mark the position of the 5
fi
xing points (4 mobile
fi
xing points
and one anti-tear bolt anchoring point).
2. Eliminate the pre-marked sections of the cable routing holes that you intend to use.
3. Use 6 mm wall plugs (supplied) to
fi
x the switchboard to the wall. Drill holes accordingly and insert the wall plugs in the wall.
4. Route the cables through the respective holes.
5. Fix the housing to the wall by tightening the screws fully home into the wall plugs, but without damaging the housing mountings.
6. You can now re
fi
t the components removed from the housing, starting with the power supply unit for the sake of convenience. To route the
conductors to the switchboard card power connector in an orderly manner, pass them below the power supply unit and then upwards, using
the two recesses in the reinforcing ribs under the PSU for the purpose.
Cable routing for
fl
ush-mounted box Art. 30002503
Cable routing for wall-mounted box Art. 30002501
DETAIL OF POWER SUPPLY UNIT CONNECTOR:
CORRECT POSITIONING
TELEPHONE
INTERFACE EARTH
CONDUCTOR
POWER SUPPLY
UNIT FIXING
SCREW
PSU
CONNECTOR
RETAINING
CLIPS
HOUSING MOUNTING HOLES
HOUSING MOUNTING HOLES
ANTI-TEAR TAMPER HOLE
