Ringing Line Preference
When you enable this feature, a station automatically connects to a ringing line when taken off-hook.
1. Go to STATIONS, then CLASS OF SERVICE.
2. Go to PAGE 3.
3. Make sure you are in the correct Class of Service.
4. Click on RINGING PREFERENCE.
5. Click APPLY.
Dialing Mode
Program the line port to provide either DTMF dialing or rotary (pulse) dialing line as required by the central
office (CO).
1. Go to LINES, then LINE PROGRAMMING.
2. Go to LINE ATTRIBUTES.
3. Select the line for which you wish to set Dialing Mode.
4. Go to LINE TYPE SPECIFIC.
5. Make sure the “Line Attributes for Line__” heading states the correct line.
6. From the Dialing Mode drop down list, select TONE or PULSE.
7. Click APPLY.
Pulse Interdigit Time and
Pulse Dial Make/Pulse Dial Break (Pulse Dial Ratio)
The system defaults the Pulse Interdigit Time to 150 msec., but you can change this to any value between 100
msec. and 1 second.
Set the make/break ratio for rotary dialing to match line requirements. You can set the make and break times in 1
msec. increments from 1 msec. to 99 msec.
1. Go to SYSTEM, then TIMING.
2. Go to DIAL TIMING.
3. In the Pulse Dialing box, use the drop-down menu to select the Pulse Interdigit Time.
4. Type the Pulse Break Time and Pulse Make Time in the corresponding boxes.
5. Click APPLY.
12 – Installing The ATI-D-1PT
IMI89–208
Installing And Programming The ATI-D-1PT