Section 11 - Installation of Car Seat in Vehicle (continued)
35
6
Route LATCH Belt in Base Belt Path:
- Slide end of Lower Anchor Belt
with Push-On Connector and
Lower Anchor Belt Adjuster down
through Vehicle Belt Path Opening
on right side of Base. Adjuster
Release Button should face
away from Base
(fig. d)
.
-
Make sure Lower Anchor Belt is
not twisted and slide Push-On
Connector at opposite end down
through Vehicle Belt Path
Opening on left side of Base
(fig. e)
.
-
Slide Lower Anchor Belt under
Vehicle Belt Guide
(fig. e)
.
(fig. d)
(fig. e)
Vehicle Belt
Guide
Vehicle
Belt Path
Opening
Push-On
Connector
Lower Anchor
Belt Adjuster
Vehicle
Belt Path
Opening
Push-On
Connector
Lower
Anchor Belt
Lower Anchor
Belt
Place base rear-facing in the vehicle seat location
selected with the Adjustable Recline Foot against
vehicle seat back and centered between the
vehicle lower anchors
(fig. f)
.
Check Base installation angle.
Bubble in Recline Indicator must be centered on
the black line marked with “22” or “35” based on
infant’s weight
(fig. g
or
fig. h)
. For more information
see “Adjusting Base for Proper Car Seat Recline” section 11a.
The Bubble in the Recline Indicator must be centered
on the black line for infant’s weight.
• For infants 22 lbs. (10 kg) or less, bubble
must be centered on line marked “22”
(fig. g)
.
• For infants 20 to 35 lbs. (9 to 16 kg),
bubble must be centered on line marked
“35”
(fig. h)
.
• Infants over one year of age and between
20 and 22 lbs.(9 and 10 kg), either black
line can be used for installing the base.
Section 11 - Installation of Car Seat in Vehicle (continued)
36
7
(fig. f)
8
22
35
(fig. g)
22
35
(fig. h)
