Section 11 - Installation of Car Seat in Vehicle (continued)
31
To adjust the base installation angle and car seat recline:
Identify the black line on Recline Indicator that will provide the
proper recline for infant.
Place base on vehicle seat and check position of Bubble in
Recline Indicator.
• If Bubble is centered on the proper line for
infant’s weight, proceed to “Securing Base
with LATCH system” section 11b or “Securing
Base with a Vehicle Seat Belt” section 11c.
• If Bubble is not centered on the proper line
for infant’s weight
(fig. h)
, adjust the base
installation angle for the vehicle seat by
continuing to follow steps 3 through 6.
1
2
(fig. h)
22
35
Bubble
NOT
centered
on line.
With bottom of Base and Recline
Adjustment Foot in contact with
vehicle seat, grasp front corner of
Base at the belt path opening
(fig. j)
.
Pull back on Recline Adjustment
Foot Lever and lift front of Base
allowing Recline Adjustment
Foot to rotate down
(fig. j)
.
Locate the Recline Adjustment Foot
position that provides the proper
installation angle for the Base (Bubble
centered on line for infant’s weight) and release the Recline Foot
Adjustment Lever to lock the Recline Adjustment Foot in place.
- Extend Recline Adjustment Foot to move Bubble toward front
of the Base.
- Push Recline Adjustment Foot up into base to move Bubble
toward rear of the Base.
Check position of Bubble in Recline Indicator, continue to adjust until
Bubble is centered on the proper line for infant and then proceed with
securing the base in the vehicle.
Section 11 - Installation of Car Seat in Vehicle (continued)
32
4
5
(fig. j)
Recline
Adjustment
Foot
Recline
Adjustment
Foot Lever
3
6
