COMBA ML-FOS, Installation Manual

Page: 26 / 31

ML-FOS Installation Guide
ML-FOS QI Copyright - refer to title page Page 26
ENU Status: 1-0-0
The descriptions of each menu are listed in the table below:
Menu Description Read/Writ
Alarm Alarming Parameters
RF Alarm Current alarm reading Read
RF Lost Read and mask/unmask the RF Lost alarm
Read/Set
RF Tx Power Read and mask/unmask the RF transmitter power alarm
Read/Set
RF -5V Read and mask/unmask the RF -5V power supply alarm
Read/Set
RF PA-I Read and mask/unmask the RF power amplifier alarm
Read/Set
RF Tx IF Read RF transmitter IF alarm
Read/Set
RF Tx PLL
Read and mask/unmask the RF transmit phase locked loop
alarm
Read/Set
RF Rx PLL
Read and mask/unmask the RF receive phase locked loop
alarm
Read/Set
Link ID Mismatch Read and mask/unmask the Link ID mismatch alarm
Read/Set
Modem Unlocked Read and mask/unmask the modem unlocked alarm
Read/Set
IF Tx PLL
Read and mask/unmask the IF transmit phase locked loop alarm Read/Set
Status Status Parameters
Status Read system status information Read
RF RF Parameters
Information
Read the information about FOS type, serial number and
firmware version.
Read
Temp Read FOS current temperature Read
SSPA Enable/disable solid state power amplifier Read/Set
Tx Power Read / set up transmitter power Read/Set
RF RSL Read receiver signal level Read
Tx/Rx Freq Read / set up transmitter frequency / read receiver frequency Read/Set
ATPC Enable
Enable or disable automatic power control function
Read/Set
ATPC Trigger Level Read / set up automatic power control trigger level Read/Set
System System parameters
System Info
Read system-related information: Type, SN, Hardware version,
Specification code, MPU firmware version, Power supply
Read
Bandwidth Read / set up the bandwidth configuration Read/Set
ETH Read / set up IP address and Mask Read/Set
Firmware update Update firmware version Set
Firmware Switch Switch between the operating firmware and backup firmware Read/Set
Link ID
Read / set up Link ID
Read/Set
SYS Time
Read / set up system time
Read/Set
Factory Settings
Revert to factory default setting
Read/Set
Save Logs
Export alarm logs
Set
Clear Logs
Clear alarm logs
Set
MPU Reset
Reset MPU
Set
SYS Reset
Reset System
Set
Table 3: CIT menu description