COMAC ULTRA 120 B-G, Use And Maintenance Manual

Page: 28 / 72

28
23. Select the speed level “step-01” and turn the knob (13) anti-
clockwise until it reaches the bottom of the scale ( Fig.17 ).
24. Shift the direction lever (14) to “reverse”, moving it in the
direction shown by the arrow ( Fig.18 ).
25. Release the parking brake by moving the parking brake lever
(15) (at the side of the operator seat) in the direction shown by
the arrow ( Fig.19 ).
ATTENTION: the indicator light (16) relating to the parking
brake will be deactivated on the control panel ( Fig.20 ).
26. Press the drive pedal (17) to begin moving the machine ( Fig.21 ).
27. Drive the machine down the ramp.
28. Engage the parking brake by moving the parking brake lever
(15) (at the side of the operator seat) in the direction shown by
the arrow ( Fig.22 ).
ATTENTION: the indicator light (16) relating to the parking
brake will be activated on the control panel ( Fig.20 ).
29. Bring the main switch (1) to "0", turning the key (2) a quarter turn
to the right ( Fig.2 ). Remove the key from the main switch.
30. Get off the machine.
ATTENTION: do not position your foot above the brush head
while the machine is coming down the ramp.
TRANSPORTING THE MACHINE (B VERSIONS)
To transport the machine safely, proceed as follows:
1. Make sure the solution and recovery tanks are empty. If this is
not the case, empty them (read “ DRAINING THE SOLUTION
TANK ” and “ DRAINING THE RECOVERY TANK ”).
2. Sit on the driver’s seat.
3. Insert the key (2) in the main switch (1) on the control panel.
Bring the main switch to "I", turning the key (2) a quarter turn to
the right ( Fig.1 ).
4. Use the i-drive adjustment switch (3) ( Fig.2 ) to select the
“transfer” program (A) ( Fig.3 ).
ATTENTION: in this way, both the brush head and the
squeegee support will move to their idle position (raised
above the floor).
5. Select the movement speed level - e.g. “step-01” - by turning
the knob (4) (on the control panel) in the direction shown by the
arrow ( Fig.4 ).
6. Select the direction in which you want to move the machine.
For example, if you want to move forwards shift the direction
selector lever (5) in the direction shown by the arrow ( Fig.5 ).
7. Release the parking brake by moving the parking brake lever (6)
(at the side of the operator seat) in the direction shown by the
arrow ( Fig.6 ).
ATTENTION: the indicator light (7) relating to the engaged
parking brake will be deactivated on the control panel
( Fig.7 ).
8. Press the drive pedal (8) to begin moving the machine ( Fig.8 ).
9. Use a ramp to move the machine up onto the transport vehicle.
17 20
21
19 18
12
2 1
1
2
14
15
15
16
17
3
3 4
4
13