COMAC C100 ESSENTIAL Series, Use And Maintenance Manual

Page: 30 / 40

EMPTYING THE SOLUTION TANK
Proceed as follows to empty the recovery tank:
1. Remove the solution tank filler cap ( Fig.1 ).
2. Remove the drainage hose of the solution tank from the clamps; it is located at the rear of the machine ( Fig.2 ).
3. Bend the end of the drainage tube in order to create a choke and prevent the content from coming out ( Fig.3 ), then position the tube on the
discharge surface, unscrew the cap, and gradually release the tube.
4. Repeat the operations in reverse order to reassemble all the parts.
1 3 2
CLEANING THE WATER SYSTEM FILTER
In order to clean the water system's filter, do the following:
1. Close the tap's output flow, and shift the knob (1) on the left hand side of the steering column ( Fig.1 ) downward.
2. Unscrew the detergent solution filter cap (3) ( Fig.2 ).
3. Remove the cartridge from the filter body and rinse under a jet of running water, and use a brush to eliminate any impurities, if necessary.
4. Once the filter cartridge is clean, repeat the operations in the opposite order to reassemble all the parts.
2 1
1
2
CLEANING THE VACUUM TUBE
Careful cleaning of the vacuum hose guarantees better cleaning of the floor as well as a longer vacuum motor life. Proceed as follows to clean the
vacuum hose:
1. Extract the vacuum tube (1) from the vacuum nozzle on the squeegee body ( Fig.1 ).
2. Remove the vacuum tube (1) via the hole on the back of the recovery tank (
Fig.2
).
3. The vacuum hose from the retainers present inside the recovery tank.
4. Rinse the inside of the vacuum hose with a jet of running water.
5. If you wish to use the tank cleaning kit to clean the vacuum tube, see “ TANK CLEANING KIT (OPTIONAL) ”
6. Repeat the operations in reverse order to reassemble all the parts.
2 1
1 1
30