Colortronic CTT 250, Operating Instructions Manual

Page: 27 / 93

&
If the unit operates with motor flaps (optional):
Granules #
Enter the drying hopper number whoose value you want to view or modify. Acknowledge with the
ENTER-key.
Granules
target: _ % = _ °C (°F)
Enter the material temperature at which the flap (optional) on the drying hopper should close.
Acknowledge with the ENTER-key.
&
This value is entered in percent of the temperature on the hopper inlet.
The material temperature calculated by the control system for closing the
flap on the drying hopper is displayed.
Granules
act.: _ °C (°F)
The current material temperature in the drying hopper is displayed (optional, if there is a flap).
Granules
dwelling time: _ min
The dwelling time of the material in the drying hopper is displayed in minutes.
Press the ”F1"-key.
64.10-0260GB05
06/03
CTT 250
Start-up 3-12