5. Maintenance
Version: 64.10-0233GB05 11/02
»
This chapter is intended for persons with skills in electrical and mechanical
areas due to their training, experience and received instructions.
Personnel using the instructions in this chapter must be instructed of the re-
gulations for the prevention of accidents, the operating conditions and safety
regulations and their implementation.
Ensure in each case that the personnel are informed.
For maintenance work taking place at heights of over approx. 6 feet, use only
ladders or similar equipment and working platforms intended for this purpo-
se. At greater heights, the proper equipment for protection against falling
must be worn.
Use only suitable lifting gear which is in proper working order and load sus-
pension devices with sufficient carrying capacity. Do not stand or work under
suspended loads!
Ensure that the electric motors/switch cabinets are sufficiently protected
against moisture.
Use only suitable workshop equipment.
Before starting maintenance work, appoint a supervisor.
Inform the responsible personnel before maintenance work on the system is
started.
Never operate the equipment when partially dismantled.
All maintenace and repair work
not
described in this chapter, may only be
carried out by Colortronic service personnel or authorized personnel (ap-
pointed by Colortronic).
L
Disconnect the equipment from mains supply before starting maintenan-
ce procedures to ensure that it cannot be switched on unintentionally.
Depressurize all compressed air piping of the equipment before starting
maintenance work.
64.10-0233GB05
11/02
CTT 1600
Maintenance 5-1
