3.5.3. Entering hopper values
Select
”Hopper”
.
Acknowledge with the ENTER-key.
or
Press the
”F4”
-key.
Hopper entry X Target
(X = number of the drying hopper)
Enter the drying temperature for hopper flap X (when operating with supplementary heating).
Acknowledge with the ENTER-key.
Hopper entry X Act.
(X = number of the drying hopper)
The current temperature at the feed opening of hopper flap X will be displayed.
&
If there is a cable break “+0 °C” is displayed.
F
The lowest drying temperature setting of the hopper flap must be the
same as or higher than the drying temperature.
Press the “
â
” key.
64.10-0233GB05
11/02
CTT 1600
Start-up 3-11
