&
If the unit operates with motor flaps (optional):
Granules X
target: _ % = _ °C
(X = number of the drying hopper)
Enter the material temperature at which the flap (optional) on the drying hopper X should close.
Confirm with the ENTER key.
&
This value is entered in percent of the temperature on the hopper inlet.
The material temperature calculated by the control system for closing the
flap on the drying hopper X is displayed in °C.
Granules X
act.: _ °C
(X = number of the drying hopper)
The current material temperature in the drying hopper X is displayed in °C (optional, if there is a
flap).
Press the ”F1"-key.
64.10-0233GB05
11/02
CTT 1600
Start-up 3-12
