Page
22
of
62
Metro (Konica Head)
Step 11:
Once excess glue is removed, run glue cycle for 30-50 min with glue dryer on.
Step 12:
Wipe off the glue from the Press Roller, with the help of cleaner damp towel.
While cleaning the Press Roller, cover the belt surface with poly sheet to avoid the glue remains falling on
the belt surface.
Step 13:
Leave machine idle for 4 hours to let glue dry and set. (Next glue coat has to be done only after
resting period of 4 hours) Above process has to be repeated for every glue coat process.
Glue Removing Preparation
Prepare and ready the following below mention things before removing glue:
•
Prepare proper ventilators.
•
Wear proper safety armament to prevent from touching glue and cleaner.
•
Put cover sheets on under belt, printer front and rear to protect them from dropped glue and
cleaner.
Note
: Do not use the Belt Washing Unit during the glue coating or glue removing process. Additionally,
glue or the cleaner may damage the brush-roller or sponge roller, thus put a cover on the washing unit.
Glue Removing Procedure
Glue coat gets damaged due to several reasons like during unpacking or unloading. Thus, service
engineer needs to remove the damaged glue coating and recoat the glue on the belt.
Follow these steps to remove glue:
Step 1:
Prepare cleaner which is dedicated to using glue.
Step 2:
Wipe cloth or paper towel with purified water. Place wipe clothes on belt to cover belt.
Fig 20: Wiping the Belt