Flush-mounting the housing
tes, and housing at the
and
o prep
is the side with the
2. P
ole.
i
ng.
holes
he three M5x20
i
hinge.
n-head
ter plate.
Note: Feed the cables through the ceiling panel, pla
appropriate time depending on whether you are using the flying lead
whether the cable is external or internal to the mounting surface.
T
are the ceiling panel perform the following
1. Remove the ceiling panel from the ceiling.
Note: Ensure that you trace the back of the outer plate: this
smaller diameter. If you trace the diameter of the front of the plate, your
mounting hole will be too large
osition the back of the outer plate on the ceiling panel at the installation
cation.
lo
3. Trace the outline of the outer plate onto the ceiling panel.
4. Use the traced outline as a guide to cut out the mounting h
To nstall the back and outer plates perform the followi
1. Insert the three M5x20 pan-head double-washer screws into the three
inside the back plate.
2. Set the back plate onto the back of the ceiling panel and center it over the
mounting hole.
3. Slide the outer plate into the mounting hole and back plate.
4. Line up the mounting holes and slots in the outer plate with t
pan-head double-washer screws in the back plate.
5. Slide the outer plate onto the screws in the back plate.
6. Rotate the outer plate to secure it to the back plate.
To nstall the housing perform the following.
e
1. Let the housing cover drop down and rest on th
2. Attach
the
housing
to the inner plate using the M4x12 pa
double-washer screws.
3. Slide the back of the housing and attached inner plate into the ou
4. Rotate the housing clockwise to slide the mounting slots on the inner plate
onto the screws in the back plate.
Back plate
Ceiling panel
Outer plate
Inner plate
M5x20
pan-headdouble-washer
M4x12
pan-head
double-washer
Top gasket
-8
-
