Repair Maintenance Guide
31
60 mm (2.4 in)
B
Warning
Always measure from left to
right, with the fixing clips closest
to you.
Mark the carrier plate
1 Turn the RGB Light Engine module with the LED strips up and fixing clips
closest to you. This is the short side with the green sub PCB at the back.
2 See table
for the carrier plate cutting position.
Mark a straight line with a pen at the carrier plate cutting position on the left
side of the panel, parallel to the longest edge.
Figure 36, Mark the carrier plate.
Cut the carrier plate
1 With a new utility knife, cut the obsolete part at the just drawn line.
2 Before the panel is mounted, clean it from cutting particles that might
have been left on the RGB Light Engine.
Figure 37, Cut the carrier plate.
3 Continue to step
A 60 mm
(2.4 in)
Fixing
clips
Sub PCB
(bottom
side)
B 120 mm (4.7 in)
C 180 mm (7.1 in)
5
10
15
20
25
30
