17
B) Assembling the Dispensing Head
Locate the parts that will be needed to assemble the
dispensing head. These parts include: A) Dispensing
head oring, B) Dispensing head, C) Piston orings (2),
D) Piston, G) Handle retaining rod, H) Dispensing
handle, and I) Retaining rod oring.
After locating all of the required parts, start by
assembling orings onto the piston.
Once the orings have been installed onto the piston,
place a bead of lubricant between the orings.
Insert the beater assembly into the freezing cylinder.
Holding the beater horizontal, gently slide it straight into
the cylinder until it can go no farther.
Once installed, rotate the beater assembly to engage the
beater frame into the drive coupling in the transmission.
This engagement will allow the beater frame to go
another ¾” into the cylinder. Push the beater frame until
it can go no further.
After installing and engaging the beater assembly, rotate
the center idlers to a vertical position. This will ensure
that they will correctly engage the pins on the rear of the
dispensing head.
C
D
A
B
H
G
I
