MASTERFLEX
®
Digital Pump Drive Operating Manual 2-1
Cole-Parmer
Section 2
Installation and Setup
•
The drive should be mounted on a flat horizontal surface.
•
The ambient air temperature should not exceed 104° F (40° C) and
adequate air flow should be provided for.
CAUTION: Do not block the rear panel of the pump drive. The
power cord must always be easy to disconnect.
•
Tubing should be clean and routed so that bend radii are at a
minimum four (4) times the tube diameter and as short as possible.
WARNING: Turn drive off before removing or installing tubing.
Fingers or loose clothing could get caught in drive mechanism.
•
Use a tube size of appropriate diameter for the flow rate and
viscosity required.
•
To maintain the best accuracy of flow rates, re-calibrate tubing
regularly. See
Tubing Calibration
section of this manual.
•
For tubing selection and compatibility, see
Tubing Selection Guide
within this CD.
•
When cleaning or performing maintenance, please remove power from
the drive.
CAUTION: The power cord set supplied with your pump drive
meets the requirements of the country where you purchased the
pump drive. If you use the pump drive in another country, you
must use a power cord set that meets the requirements of that
country.
DANGER: High voltages exist and are accessible. Use extreme
caution when servicing internal components.
Before Starting Drive