Page 10
•
Pressing the
[Unit/
]
key will display the net weight (pcs and kg), pressing it
second time will display the unit weight (g/pcs) and the third time, it will be the
count again (pcs).
•
Press the
[Pcs/
]
key to return to normal weighing. Press the
[Pcs/
]
key again
to start counting a different sample.
CHECK-WEIGHING
Check-weighing is a procedure to cause lamps to come on (and if enabled, an alarm to
sound) when the weight on the scale meets or exceeds values stored in memory. The
memory holds the last values for a high and a low limit when the power is turned off. The
user can set either one limit or both as described in section 7.1. The limits can be set when
the scale is in weighing or parts counting modes. After limits have been set the Check-
weighing function is enabled.
When a weight is placed on the scale the LED’s above the display will show if the weight is
above or below the limits and the beeper will sound as described below, if the beeper is
enabled (see section 7.1).
The relay outputs are open collector drivers to control an external relay. The relays will be
active when the corresponding LED is on during check-weighing. The ZERO relay output will
be on when the scale is showing the display is at Zero.
ACCUMULATED
TOTAL
•
The scale can be set to accumulate manually by pressing the
[Print/M+/Esc]
key or automatically when a weight is removed from the scale. See Section 7.3
for details of setting the Parameter “
C3 PRM
” and “
C4 Aon
”. The accumulation
function is available when weighing or when counting parts. However the
memory is cleared if the weighing units or functions are changed.
•
When the weight (or count) displayed is stored in memory the display will show
“
ACC 1
” and then the total in memory for 2 seconds before returning to weighing.
The RS-232 interface will output to a printer or PC.
•
Remove the weight, allowing the scale to return to zero and put a second
weight on.
When this value is stored, the display will show “
ACC 2
”, then the
new total and finally the value of the second weight. Repeat as necessary to
add all the values needed to the memory.
•
To view the total in memory press the
[Print/M+/Esc]
key when there is no
weight on the scale. The display will show the number of entries and the total.
•
To clear the memory (set the value to zero) press the
[Func/C]
key during the
time the totals are being displayed.
Summary of Contents for IPSW 100
Page 1: ...IPSW Series Washdown Scales User Manual xxxxxxxxxx Revision A June 2017 ...
Page 2: ......
Page 3: ......
Page 4: ......
